Great Artesian Basin

Green areas are the low-lying areas. Most of these area are part of the Great Artesian Basin: see ref #2 for a better map
Great Artesian Basin in Australia
Geological strata giving rise to an artesian well. The principle is the same for a huge basin
Schematic of an artesian well

The Great Artesian Basin in Australia is the largest and deepest aquifer (artesian basin) in the world. It stretches over 1,711,000 square kilometres (661,000 sq mi), which is 22% of the surface area of Australia. This includes most of Queensland, the south-east corner of the Northern Territory, the north-east part of South Australia, and northern New South Wales. The basin is 3,000 metres (9,800 ft) deep in places. It may contain 64,900 cubic kilometres (15,600 cu mi) of groundwater.[1] Its temperature ranges from 30°C to 100°C.[2]

The basin is the only reliable source of freshwater through much of inland Australia.[2] The Great Artesian Basin Coordinating Committee (GABCC) coordinates activity between the various levels of government and community organisations.[3]

Geology

The water of the GAB is held in a sandstone layer laid down by continental erosion of higher ground during the Triassic, Jurassic, and Lower Cretaceous periods. At the time when much of what is now Australia was below sea level. The sandstone was then covered by a layer of marine sedimentary rock. This formed a confining layer, trapping water in the sandstone aquifer. The eastern edge of the basin was uplifted when the Great Dividing Range formed. The other side was created from the landforms of the Central Eastern Lowlands and the Great Western Plateau to the west.

Most water enters the rock formations from the higher ground near the eastern edge of the basin (in Queensland and New South Wales). It very gradually flows towards the south and west.[1] A much smaller amount enters along the western margin in arid central Australia, flowing to the south and east. Because the sandstones are permeable, water gradually makes its way through the pores between the sand grains, flowing at a rate of one to five metres per year.

Discharge water eventually exits through a number of springs and seeps, mostly in the southern part of the basin. The age of the groundwater is got by measuring carbon-14 and chlorine-36. It ranges from several thousand years for the recharge areas in the north to nearly 2 million years in the south-western discharge zones.[4]

Great Artesian Basin Media

References

  1. 1.0 1.1 "Underground water factsheets: Great Artesian Basin" (PDF). Department of Environment and Resource Management. Archived from the original (PDF) on 29 July 2012. Retrieved 30 September 2010.
  2. 2.0 2.1 Spanevello M.D. 2001. The phylogeny of prokaryotes associated with Australia's Great Artesian Basin Archived 2012-04-15 at the Wayback Machine. Griffith University PhD dissertation. Accessed 2009-07-26.
  3. "GABCC website". Archived from the original on 2007-02-07. Retrieved 2013-02-06.
  4. Mudd, G.M. 2000 (2000). "Mound springs of the Great Artesian Basin in South Australia: a case study from Olympic Dam". Environmental Geology. Springer Berlin / Heidelberg. 39 (5): 463–476. doi:10.1007/s002540050452. S2CID 54687235.[dead link]